SpamCipher Help Center

How to keep a list clean automatically

Connect your email tool and have SpamCipher check its new contacts on a schedule

Updated 19 November 2026

Auto-Sync checks a list in your email marketing tool on a schedule, so addresses that go bad are caught before the next campaign bounces on them. It verifies only the contacts that are new or have not been checked recently, and it can write the result back as a tag, or remove the invalid ones, so the list in your tool stays clean on its own.

Note: What it costs: 1 credit per address checked, the same as a bulk check. Addresses checked in the last 30 days are reused for free, so a weekly schedule on a slow-moving list costs very little.
Note: Needs a connected tool. Mailchimp, Klaviyo, Brevo, Campaign Monitor, Constant Contact and GetResponse connect with an API key; more are under Add Integration.

Before you start

  • An email marketing tool connected under Integrations
  • About 5 minutes

Set up a schedule

Step 1: Connect the tool first

  • Open Integrations in the left menu and connect the tool your list lives in. The connect guide walks through it.
  • A schedule can only be made for a connected tool.

Step 2: Open Auto-Sync

  • Open Email Validation under Deliverability, click Bulk Verify, then Schedule Validation at the top right.
  • The console lists your schedules, how many are active and your credits.

Step 3: Pick the list and the schedule

  • Click + New Schedule. The dialog walks through five steps: the tool and the list, what to check, how often, what to write back, and a review.
  • Daily, weekly or monthly is enough for most lists. Check only new contacts to keep the cost down.
  • Writing back tags each address in your tool with its result, or removes the invalid ones; choose what your tool and your team expect.

Keep an eye on it

Step 4: Read the runs

  • Each schedule shows its last run, what it found and when it runs next. Pause it from its card when you do not want it to spend.
  • The same results also appear under Email Validation Results on the Bulk Verify page, like any other check.

Troubleshooting

The dialog says no tools are connected

Connect one under Integrations first. The API key for most tools is under the tool's account settings; the connect card says where.

A run checked far more than the new contacts

The schedule is set to check the whole list. Edit it and choose new contacts only; the first run after a change still checks everything once.

I do not want anything removed from my tool

Choose tag instead of remove under write back, or turn write back off. The results still show here, and you decide what to do with them.